|
 Evaporative Cooler Control
|
8316G064
|
Three-Way Water Solenoid Valve. 1/2" Pipe Thread. 120V, 60Hz. Normal Closed Pressure Connection. Normally Open Exhaust Connection.
|
|
|
|
LLC44B30A
|
CONTROLLER - Evap Cooler Liquid Level Controller
|
|
|
|
EC - CONTROL KIT - NO FREEZE PROTECTION
|
EVAPORATIVE COOLER ELECTRICAL CONTROL KIT USED IN BOTH STANDARD AND CELDEK TYPE UNITS WITHOUT THE FREEZE PROTECTION OPTION. INCLUDES INTAKE AIR THERMOSTAT, FLOAT SWITCH, FLOAT SWITCH MOUNTING HARDWARE AND TIMER WIRED TO ELECTRICAL BOARD.
|
|
|
EC - CONTROL KIT -WITH FREEZE PROTECTION
|
EVAPORATIVE COOLER ELECTRICAL CONTROL KIT USED IN BOTH STANDARD AND CELDEK TYPE UNITS WITH THE FREEZE PROTECTION OPTION. INCLUDES DUAL SET-POINT INTAKE AIR THERMOSTAT, FLOAT SWITCH, PRESSURE SWITCH, FLOAT SWITCH MOUNTING HARDWARE AND TIMER WIRED TO ELECTRICAL BOARD.
|
|
|
EC-FPDK-Evap
|
Freeze Protection Drain Control kit for Evaporative Coolers. Includes 3-Way water solenoid valve 8316G064 (shipped loose), Pressure switch installed upstream of 2way solenoid in unit, Brass Tee, 2 NPT half inch nipples, and two stage thermostat T678A1361. Field wiring required by others for 3-way valve. For both Celdek and Standard V-bank type Configurations.
|
|
|
EC240A
|
SOLENOID CONNECTOR - Cable Solenoid Connector with 3' Pigtail 3 Conductor Jacket. Old part# CZ2-01. EC240
Approved replacement part: CM1 N02 VL2 B02
|
Used In
|
|
FS3201-122
|
Liquid level sensor - Float switch for MPUs and RTU. Hardware Specifications: 1/8" NPT. 20ft wire leads.
|
Used In
|
|
FS3201-207
|
Liquid level sensor - Float switch for standard evap & celdek evap. Hardware Specifications: 1/8" NPT. 6ft wire leads. (REPLACES PART AQ5510)
|
Used In
|
|
P1011-6
|
SUB BASE for LLC44B30A Evap Liquid Level Controller
|
|
|
|
|
