Blower Housing
|
G10D
|
10" forward curved, centrifugal blower. Galvanized finish. 0-4000 CFM. 2500 max. RPM. LH-RCD (Left Hub, Right Center Disk) 8 weldnuts. Used on units with standard airflow & down discharge configurations or opposite airflow & side or up discharge configurations. Use P/N G10D RH-LCD or for units with standard airflow & side or up discharge configurations or opposite airflow & down discharge configurations. Not for use with Nidec ECM motors.
|
|
|
G10D RH-LCD
|
10" forward curved, centrifugal blower. Galvanized finish. 0-4000 CFM. 2500 max. RPM. RH-LCD (RIght Hub, Left Center Disk). 8 weldnuts. Used on units with standard airflow & side or up discharge configurations or opposite airflow & down discharge configurations. Use P/N G10D for units with standard airflow & down discharge configurations or opposite airflow & side or up discharge configurations. Used with Nidec ECM motors in all blower configurations.
|
|
|
|
9090015
|
18" forward curved, centrifugal blower. Permanently lubricated pillow-block ball bearings. Enamel finish. 4000-12000 CFM. 1 3/16" x 34" Shaft. 1450 max RPM. Heavy duty angle iron framing. Used in heated and non-heated supply units. 18-18
|
|
|
918
|
18" forward curved, centrifugal blower. Pillow-block bearings. Enamel finish framing, G90 housing. 4000-12000 CFM. 1 3/16" x 34" Shaft. 1450 max RPM. Heavy duty angle iron framing. Used in heated and non-heated supply
|
|
|
B2DRSP
|
AHU 2 DOOR SUPPORT
|
|
|
|
|
|