The manifold and electrical controls are directly mounted into the cabinet on either end of the hood. The manifold is configured based on the model chosen and includes main shutoff valve, temperature and pressure gauge, ¾”solenoid valves and a vacuum breaker. A surfactant tank, surfactant pump and push to prime button will also be installed in the cabinet. All surfactant injection shall be done after the vacuum breaker backflow prevention.

The piping and wiring are done at the factory to minimize labor at the job site. The water inlet shall be a ¾” NPT pipefitting. The hood includes a drain with a 1 ½” NPT pipe, unless the exhaust hood is over 10’ long or 30” tall, in which case two drains shall be installed.

• W1 = Hot Water Wash
• W2 = Cold Water Mist
• W3 = Cold Water Mist and Hot Water Wash
• W4 = Hot Water Wash with addition of Energy Management System (EMS)
• WF = Hot Water Wash with Fans Thermostatically Controlled
• W1REMOTE = Additional Manifold if needed for Hot Water wash option
• W2REMOTE = Additional Manifold if needed for Cold Water Mist option
• W3REMOTE = Additional Manifold if needed for Hot Water wash option

• Fully Integrated Self Cleaning Hood
• Operation and Installation Manual